BTT UPS 24V V1.0 Module Resume Printing While Power Off Module

⚡Product Introduction：

BTT UPS 24V V1.0 is an external module of the 3D printer with the function of power off resume print, which was launched by the 3D printing team of Shenzhen Big Tree Technology CO., LTD. It is applicable to all 3D printers powered by DC24V switch power, such as Ender 3 printer.

⚡Product Features：

Adopt voltage comparator LM393 chip, which can detect power failure sensitively

Equipped with 9 2.7V 5F supercapacitors to store electricity, so that there is sufficient power supply after detecting the power failure, then the printer can successfully complete the corresponding operation

An anti-reverse protection circuit is added at the power interface to prevent irreversible damage caused by the reverse power supply, which greatly protects the circuit board

The module is small and easy to install

Main function: realize the power off resume print function

⚡Module Parameters：

External dimension：52.53*50mm

Installation dimensions：44.58mm*39.38mm

Power input：DC24V

Logic voltage：3.3V or 5V

Support model：All DC24V powered 3D printers are available（like Ender3）

⚡Module Power-on:

After BTT UPS 24V V1.0 power on, D2 red light in the lower-left corner will go on, indicating normal power supply.

⚡Note:

Our company will not be responsible for any loss caused by wiring.

This module only supports the DC24V power supply. Please confirm that your printer is powered by DC24V power supply before installation；

The input power only supports DC24V. Please pay attention to distinguish the positive and negative poles when wiring. The wiring process must be carried out in the state of a power failure and confirm the wiring is correct before power on.