Home
Shop
Wishlist0
14
d
:
05
h
:
49
m
:
18
s

RAMPS 1.4 Control Board

150,00 EGP

Buy Now
SKU:ramps14
RAMPS 1.4 Control Board Panel Part Motherboard 3D Printers Parts Shield Red Black Controls Ramps 1.4 Board Accessories
Fully assembled & tested, no soldering required.
It is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
The modular design includes plug in stepper drivers and extruder control electronics on an MEGA shield for easy service, part replacement, upgrade-ability and expansion.
A number of expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack.
It has provisions for Cartesian robots and extruders.Expand to control and other accessories.
MOSFET for heater / fan output and 3 thermistor circuits.
Fusion 5A for additional safety and component protection.
Additional 11a fuse for heating bed control.
Suitable for 5 pololu stepping drive board.
Pololu board pin outlets, so they can be easily replaced or removed for future design.
12C and SPI pins are reserved for future expansion
All MOSFETs are connected into PWM pins for versatility.
The servo connector is used to connect to the end stop, motor and led. These connectors are gold-plated, rated 3a and very compact.
SD card is now available by Kliment – stamps
When LED indicates heater output
Option 2 motors connected to Z prusa Mendel
Colour: Red
Material: PCB
Size: 10.15×6.05×1.5cmPackage Contents:
1 * 3D printer controller for RAMPS 1.4Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Back to Top
Product has been added to your cart